Hollow Rivet rolling tool, Hood Bumpers & Corner Leathers, Floor Plates

[Mitch]

Here is my Tonka toy rivet tool whch is used for the hollow rivets on the hood and the floor board plates. This tool comes with your choice of die size so the 5/32 is what you would need.
And yes these things are around $100.00

[BNCHIEF]

Want to do good work get good tools, Mitch I got to thinking may have to have you bring a tool to branson and do a job for me old buddy, old pal and payment comes in the way of dinner for you and your wife and me and mine plus she is sociable and nice and then there is me but I will have the moula for dinner.

[Mitch]

Well my wife won't be going but my friend will be.
I would be more than happy to bring a tool or two with no strings attached

[BILL WILLIAMSON]

Rivets are like Apple Pie, they look better with that "HOMEMADE" look---
KDad Hungry

[DaWizard]

And here I anticipated you saying "they look better with that homemade vanilla ice cream atop them".

[BILL WILLIAMSON]

Apple Pie without cheese is like a HUG without a SQUEEZE!
Bill W.

[Mike]

Mitch,
Who makes the tool and where can I purchase it?

Mike

[Dan Partain]

Here's another option for the semi tubular rivets. I purchased a rivet tool a couple of weeks ago and used it with great results on a inner window channel. The channel inside the door had been torn out on a 29CC pickup and was missing. I was able to find another original replacement piece. I have the support bracket riveted to the window channel and ready to go back in. In this case, the C clamp type rivet tool would not work since I will have to reach inside the door with the tool to form the rivets. I made a very small bucking bar to fit the head of the rivet but you could probably use a flat piece of metal since these 5/32" rivets are so lightweight. The tool runs about $25 at most of the A vendors.

[Mitch]

Dan that is a good idea, thanks for sharing it!

[DaWizard]

Hey Mitch, forgive my ignorance, but what is the use of the center piece on your rivet tool?

[Mitch]

watch the video on the link below

[Mitch]

Mitch,
Who makes the tool and where can I purchase it?

Mike

Mike check this place out, you want the 5/32 dies (pony 3 way 3225)

http://tubularrivetclincher.yolasite.com/

[Mike]

thank you buddy

[Mitch]

You can always borrow mine,, it's just sitting there

[Mike]

they are out of stock for now.

[Mitch]

I would call

http://tubularrivetclincher.yolasite.com/contact-us.php

[Mike]

ok I will do that tomorrow! thanks again.

[Bob C]

I use one of these. http://www.aircraftspruce.com/catalo...p?recfer=23513

Bob

[BILL WILLIAMSON]

YOUSE are the Guys that keep the Tool Trucks in business!
KDad Broke

[frankn]

I use one of these. http://www.aircraftspruce.com/catalo...p?recfer=23513

Bob

Yes I saw that looked like it would do the job