-
3~ Tudor's & 1~ Coupe
Henry Ford said,
"It's all nuts and bolts"
"Start by doing what's necessary; then do what's possible; and suddenly you are doing the impossible."
Mitch's Auto Service ctr -
Jim, in the past I was told that the later style was first introduced in April of 28. Has there been any evidence found in the archives that support that? Or is that date the change of the contact block only? Thanks Rod"Much of the social history of the Western world, over the past three decades, has been a history of replacing what worked with what sounded good." Thomas SowellComment
-
The dates in the standards are the only ones I'm aware of. since ford outsourced the horn, I doubt good records existComment
.png){kind=spacer}
-
Electrical system, wiring and troubleshooting information
This MAFCA,,,,PDF has some errors which are corrected in post #2 below below. The improper pictures have been removed, and new ones were added.
1. Connecting the horn wires
2. The flag terminal ends on the instrument panel harness, should go to the junction box. The straight round wire ends goes to the instrument...04-12-2020, 04:27 PM -
-
Spindle Connecting Rod / Tie rod. A-3280
...03-01-2021, 09:06 AM -
Last October I inquired about finding a engine rebuilder in Michigan. I received a few replies and ended up choosing a rebuilder in south west Michigan. My brother in law and I dropped it off at the end of November and we were told it would take about 8 weeks to get the bearings poured and it partially assembled. I printed out a scope of work of what we wanted to be completed so there would be...05-10-2019, 08:12 AM -
-
-
-
Right and Left spindle Arms
...03-01-2021, 09:28 AM -
OK, so here are the scans of the entire service charges booklet from 16 February 1931:
Brad in Maryland
...02-12-2020, 01:05 AM -
Comment