my 31 Victoria project came with two black trash bags of old interior parts I had not opened. Imagine my delight in seeing this, the best instructions you could ever follow. Every interior panel, carpet and windlaces with every screw or clip or snap hole. I have a new Lebaron Bonney kit and it will be modified as needed by using these patterns.
-
You do not have permission to view this gallery.
This gallery has 3 photos. -
They will make nice garage wall decorations when you're done with them3~ Tudor's & 1~ Coupe
Henry Ford said,
"It's all nuts and bolts"
"Start by doing what's necessary; then do what's possible; and suddenly you are doing the impossible."
Mitch's Auto Service ctr -
I might make a mohair suit, Barney Fife said you can't wear them out!Originally posted by Mitch View PostComment
-
If have tried to research this and have not been successful.
Has anyone attempted to dye their fabric on the seats. To be specific I have recently purchased a Victoria, the car is exceptionally nice on the exterior. Unfortunately the interior is a broadcloth and has stains throughout. I have tried every method I could think of to remove the stains with very limited success. I am almost ready...11-23-2020, 03:00 AM -
I’ve made some progress on the interior. I have a Lebaron Bonney kit. I have had every panel on and off several times to trim, cut, and refit . I Have the original panels to guide me and have been able to follow the original nail holes in some of the wood. In the picture the door panel is not attached, it is just hanging fo a trial fit as is the panel above the door. I called Lebaron Bonney last...You do not have permission to view this gallery.
This gallery has 1 photos.01-12-2018, 09:43 PM -
Is there anyone that offers a stock interior kit for 37 Ford fordor 78? ...11-19-2019, 08:09 PM -
What are these parts that were in my Lebaron Bonney Victoria interior kit. The long piece is about 55 inches and I think it goes across the top of the rear seat back....You do not have permission to view this gallery.
This gallery has 1 photos.01-20-2018, 08:54 AM -
so I figure my new reality won’t offer the roadster to be repainted any time soon and I’ve had a LB interior kit in the rafters of garage since 1983. Pulled the boxes down and everything looked new still, albeit not close to original in many ways, it’s still new. I got the door panels and cowl panels in place, but will need to pull out wood to seal before going further. Here’s a couple shots...You do not have permission to view this gallery.
This gallery has 3 photos.05-04-2018, 09:51 AM -
how are the interior panels installed on a roadster P/U? Are the screws exposed? Just got home from vacation...lots of parts on porch. Lot of posts on here to catch up on and lots of work to do on truck....dammit I'm behind on everything!!!07-16-2017, 08:17 PM -
Does anyone sell interior trim screws which are the same as original. Brass, French head #10 and #12 oval head screws?10-09-2019, 05:36 PM -
Am researching, trying to find info on my Pick Up interior as it looked like as Henry made it. What I remember from seeing other trucks that have been refurbished, interior panels/cards on those trucks were vinyl covered panels, or plastic panels. Also these trucks, have every possible inside Cab space covered with material/cards.
I think my truck, which has a couple of door cards...01-17-2019, 12:39 PM -
-
Not sure if Ford, but they came out of a '31 standard fordor. Very Art Deco in design. Help(?)...08-30-2020, 06:31 PM
Comment