No announcement yet.

New info source

  • Filter
  • Time
  • Show
Clear All
new posts

  • New info source

    Kool, a new outlet for information.

  • #2
    welcome Ray
    3 ~ Tudor's
    Henry Ford said
    "It's all nuts and bolts"

    Mitch's Auto Service ctr


    Related Topics


    • 38buschwacker
      40 deluxe convertible
      by 38buschwacker
      Hi buschwacker here new to the forum. I have a 40 convertible having a very difficult time finding hardware bolts etc. not very many pictures either. It was completely apart when I got it. Any help or direction would be greatly appreciated .
      02-02-2018, 10:09 AM
    • Mitch
      MTFCA T library and tech info
      by Mitch
      Lots of technical info is on this site!!

      Encyclopedia tech info
      07-31-2018, 11:13 AM
    • thom
      Anybody here?
      by thom
      If anybody is here, Merry Christmas. I'm in western NC with a 1921 Touring. Nice to find another model T forum. I'll check back to see if anyone else shows up.
      12-24-2017, 11:24 PM
    • Fourdy
      Just got approved
      by Fourdy
      Just found this site and look forward to participating in the sharing of info both given and received. I have a 24 T and a 40 tudor both flattys and a blower in the 40. All body, paint and upholstery done by yours truly.
      You do not have permission to view this gallery.
      This gallery has 2 photos.
      06-29-2018, 12:03 AM
    • Mitch
      Welcome ~ Introductions
      by Mitch
      06-04-2017, 08:34 PM
    • Apple Green Wheels Rule
      Here's one for the knowlegable.........
      by Apple Green Wheels Rule
      I seek the prices on used car lot's, say in 1934, that dealers would be asking for a 1931 Ford coupe in good runnable condition with not too many miles. Need this info for research reasons.

      Who can help???????????????????
      02-01-2018, 01:36 PM
    • old victoria
      gene french line bore
      by old victoria
      anyone using one of gene frenches line bore fixture? good bad?
      03-16-2018, 05:07 PM
    • Zimmlitt
      Babbit recommendations
      by Zimmlitt
      Can anyone recommend a shop to re-pour and line bore model A main bearings in the North East? I have been using the Babbit Pot for a number of years but they are on vacation until the end of March and I would like to get this job started before then. Any recommendations in NH, ME, VT, NY, MA or CT would be appreciated.

      02-13-2018, 09:15 AM